Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2003 >> Venture Base, Van Cargo Extended >> Repair and Diagnosis >> External Pages >> Different car >> Section 130 (Wiper System And Washer System) >> Repair Instructions >> Wiper Blade Element Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.

Important:  Keep the wiper blade claws in the rubber claw channel of the wiper blade element. Do not allow the claws of the wiper blade to contact the metal spline of the wiper blade element.

  1. Insert the open end of the wiper blade element into the bottom claws of the wiper blade.
  2. Guide the wiper blade element through the wiper blade claw sets.
    Fig 1: Installing Bottom Claws & Wiper Blade
    G01813080Courtesy of GENERAL MOTORS CORP.
  3. Engage the bottom claw of the wiper blade into the notches in wiper blade element.
  4. Install the wiper blade onto the wiper arm. Refer to Wiper Arm Blade Replacement .
    Fig 2: Installing Wiper Blade Onto Wiper Arm
    G01813081Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals