Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2003 >> SSR Base >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Seat Belt System >> Repair Instructions >> Seat Belt Retractor Anchor Plate Replacement >> Installation Procedure

Installation Procedure

  1. Position the seat belt retractor anchor plate into the vehicle.
    2. Fig 1: View of Seat Belt Retractor Anchor Plate
    GM1344148Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Tighten the seat belt retractor anchor plate.

    Tighten:  Tighten the seat belt retractor anchor plate to 70 N.m (52 lb ft).

  3. Install the seat belt. Refer to Seat Belt Replacement - Front .
scientia non olet · About Mike's Workshop Manuals