Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2003 >> SSR Base >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat System >> Repair Instructions >> Finish Panel Replacement - Front Seat - Front >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Front Finish Panel Screws
    GM1229816Courtesy of GENERAL MOTORS CORP.
  1. Align the front finish panel to the seat assembly by hooking the tabs into the slots in the outer trim panel.
  2. Align and install the inboard clip in the slot on the seat frame.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the 2 screws retaining the front finish panel to the seat assembly.

    Tighten:  Tighten the front finish panel screws to 1.5 N.m (13 lb in).

scientia non olet · About Mike's Workshop Manuals