Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2003 >> Corvette Base, 2D Convertible, Standard >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System And Washer System >> Repair Instructions >> Wiper Drive System Module Replacement >> Removal Procedure

Removal Procedure

  1. Remove the air inlet grille panel. Refer to AIR INLET GRILLE PANEL REPLACEMENT in Body Front End.
  2. Using the J 39232, disconnect the wiper transmission from the wiper motor crank arm to aid in the removal of the wiper drive system module.
  3. Remove the wiper drive system module screws.
  4. Remove the wiper drive system module from the cowl area to gain access to the wiper motor electrical connector.
  5. Disconnect the wiper motor electrical connector.
  6. Remove the wiper drive system module from the vehicle.
    Fig 1: Wiper Drive System Module Screws
    G01453461Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals