Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2002 >> Venture Plus >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Power Steering Pump Flow Control Valve Replacement - Off Vehicle (CB Series) >> Assembly Procedure

Assembly Procedure

  1. Install the flow control spring (2) to the hydraulic pump housing assembly (1).
    Fig 1: Power Steering Pump Flow Control Valve (CB Series)
    G01826951Courtesy of GENERAL MOTORS CORP.
  2. Install the control valve assembly (3).
  3. Lubricate the O-ring seal (4) with power steering fluid.
  4. Install the O-ring seal (4) onto the O-ring union fitting (5).
    NOTE: Refer to FASTENER NOTICE .
  5. Install the O-ring union fitting (5) into the hydraulic pump housing assembly (1).

    Tighten 

    Tighten the fitting (5) to 75 N.m (55 lb ft).

scientia non olet · About Mike's Workshop Manuals