Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2002 >> Venture Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 1281 (Power Steering System) >> Repair Instructions >> Power Steering Pump Flow Control Valve Replacement - Off Vehicle (TC Series) >> Assembly Procedure

Assembly Procedure

WARNING: This page is about a different car, the 2002 Cadillac Eldorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the flow control spring (2) to the hydraulic pump housing assembly (1).
  2. Install the control valve assembly (3).
  3. Lubricate the O-ring seal (4) with power steering fluid.
  4. Install the O-ring seal (4) on to the O-ring union fitting (5).
    NOTE: Refer to FASTENER NOTICE .
  5. Install the O-ring union fitting (5) into the hydraulic pump housing assembly (1).

    Tighten 

    Tighten the O-ring union fitting (5) to 75 N.m (55 lb ft).

    Fig 1: Identifying Power Steering Pump Flow Control Valve Components
    G01651573Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals