Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2002 >> Tracker 2D Utility, RWD, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1420 (Power Steering System) >> Repair Instructions >> Power Steering Pressure Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Tracker. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  1. Install the PSP switch (2) into the power steering pump (3).

    Tighten 

    1. Tighten the PSP switch to 27 N.m (20 lb ft).

  2. Connect the PSP switch electrical connector (1).
  3. Bleed the air from the power steering system. Refer to BLEEDING THE POWER STEERING SYSTEM   in Power Steering System.
    Fig 1: Installing PSP Switch From Power Steering Pump
    G01469158Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals