Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2002 >> Tracker 2D Utility, RWD, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1247 (Power Steering System) >> Repair Instructions >> Power Steering Pump Flow Control Valve Replacement - Off Vehicle >> Assembly Procedure

Assembly Procedure

WARNING: This page is about a different car, the 2003 Pontiac Grand Am and 2003 Oldsmobile Alero. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the flow control spring (2) to the hydraulic pump housing assembly (1).
  2. Install the control valve assembly (3).
  3. Lubricate the new O-ring seal (4) with power steering fluid.
  4. Install the O-ring seal (4) on to the O-ring union fitting (5).
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  5. Install the O-ring union fitting (5) into the hydraulic pump housing assembly (1).

    Tighten 

    Tighten the O-ring union fitting to 75 N.m (55 lb ft)

    Fig 1: Power Steering Pump Flow Control Valve
    G01516637Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals