Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2002 >> Tracker 2D Utility, 4WD, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Repair Instructions >> Cruise Control Servo Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Installing Cruise Control Servo Assembly To Vehicle
    GM488527Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  1. Install the cruise control servo assembly (6) to the vehicle. Secure the assembly with the 3 bolts (2).

    Tighten:  Tighten the cruise control servo assembly mounting bolts to 10 N.m (89 lb ft).

  2. Connect the cruise control servo assembly electrical connector.
    3. Fig 2: Installing Cruise Control Servo Cable To Actuator Lever
    GM488533Courtesy of GENERAL MOTORS CORP.
  3. Install the cruise control servo cable (3) to the cruise control actuator lever (1).
  4. Adjust the cruise control servo cable locknuts (5) in order to adjust the cruise control servo cable play.
  5. Adjust the cruise control servo cable play to 1-2 mm (0.04-0.08 in) at the servo closed throttle position.

    Tighten:  Tighten the cruise control cable locknut (5) to 5 N.m (44 lb in).

    6. Fig 3: Installing Module Cover
    GM488523Courtesy of GENERAL MOTORS CORP.
  6. Install the cruise control module cover (1).
scientia non olet · About Mike's Workshop Manuals