Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2002 >> Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL6 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls Self-Diagnostics - 5.7L - Bi-Fuel >> Programming >> Programming Theft Deterrent System Components >> 10-Minute Learn Procedure

10-Minute Learn Procedure

NOTE: This procedure requires a Tech 2 scan tool and a Techline(tm) terminal with current Service Programming System (SPS) software.
  1. Connect Tech 2 to vehicle.
  2. Select "Request Information" under "Service Programming".
  3. Disconnect Tech 2 from vehicle and connect it to a Techline(tm) terminal.
  4. On the Techline(tm) terminal, select "Theft Module Re-Learn" under "Service Programming".
  5. Disconnect the Tech 2 from the Techline(tm) terminal and connect it to the vehicle.
  6. Turn ON ignition, with engine OFF.
  7. Select "VTD Re-Learn" under "Service Programming".
  8. Attempt to start engine, then release key to ON. The vehicle will not start.
  9. Observe the SECURITY indicator lamp, after about 10 minutes the indicator lamp will turn OFF. The vehicle is now ready to relearn the Passlock(tm) Sensor Data Code and/or password on the next ignition switch transition.
  10. Turn ignition off and wait 5 seconds.
  11. Start engine. The vehicle has now learned the password.
  12. With Tech 2 scan tool, clear any DTCs.
scientia non olet · About Mike's Workshop Manuals