Crankshaft Position Sensor: Installation
NOTE:
The engine was designed for starter motor mounting without shims. However, if single or double shims have been added to correct a noise or engagement condition, reinstall the shims in their original location to ensure proper pinion-to-flywheel engagement.
- Install CKP sensor. Install the CKP sensor retaining bolt and tighten to specification. See TORQUE SPECIFICATIONS . Connect CKP harness connector. Lift the starter motor into position. Install the positive cable lead at starter solenoid.
- Install the positive battery cable nut at starter solenoid. When installing the starter lead, ensure the starter lead is wrapped with heat protective tape. Ensure the starter lead does not contact the positive cable and/or connection. Install the wiring harness starter lead and washer.
- Install the wiring harness starter lead nut. Raise the starter motor to the engine block. Install the starter motor bolts. Tighten starter bolts to specification. Install the left side catalytic converter. Lower the vehicle. Perform CRANKSHAFT POSITION (CKP) SENSOR VARIATION LEARN PROCEDURE. See COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION.