Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2001 >> Venture Base, Van Cargo Extended >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Body Control Modules >> Removal & Installation >> Supplemental Inflatable Restraint System Sensing & Diagnostic Module >> Removal

Supplemental Inflatable Restraint System Sensing & Diagnostic Module: Removal

  1. SDM is located under passenger seat. See Figure . Disable SIR system. See DISABLING & ACTIVATING AIR BAG SYSTEM in appropriate AIR BAG RESTRAINT SYSTEMS article.
  2. Disconnect seat belt harness connector from body wiring harness. Disconnect power seat connector from body wiring harness (6-way power seat only). Disconnect both seat back and seat cushion heated seat element connectors from harness.
  3. Open under-seat storage tray. Depress tab located inside of storage tray, near center rear of storage tray. Pull storage tray forward until storage tray disengages from tracks. Remove storage tray.
  4. Remove seat nuts and washers from seat studs. Remove seat from vehicle. Remove passenger front carpet retainer, then roll back carpet.
  5. Push locking tab and release Connector Position Assurance (CPA) from SDM wiring harness connector. Disconnect SDM wiring harness connector. Remove SDM bolts and washers. Remove SDM.