Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2000 >> Impala LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Control System - Removal & Installation, Overhaul) >> Ignition Systems >> Ignition Control Module (C I) >> Removal & Installation (3.8L)

Removal & Installation (3.8L)

WARNING: This page does not describe the selected car, but rather 36 other vehicles, including the 2001 Saturn SW2, 2001 Saturn SL2, 2001 Saturn SL1, 2001 Saturn SL, and 2001 Saturn SC2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable. Disconnect 14-pin connector at ignition control module. Disconnect spark plug wires from coil pack. Remove 6 screws retaining coils to ignition control module. Remove ignition coils from module.
  2. Remove screws and washers securing ignition control module to bracket. Remove ignition control module. To install, reverse removal procedure. Tighten retaining screws to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About Mike's Workshop Manuals