Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2000 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 258 (Power Steering System) >> Repair Instructions >> Power Steering Pump Flow Control Valve Replacement - Off Vehicle >> Assembly Procedure

Assembly Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the flow control spring (2) to the hydraulic pump housing assembly (1).
  2. Install the control valve assembly (3).
  3. Lubricate the new O-ring seal (4) with power steering fluid.
    Fig 1: Exploded View Of Power Steering Pump
    GM428353Courtesy of GENERAL MOTORS CORP.
  4. Install the O-ring seal (4) on to the O-ring union fitting (5).
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the O-ring union fitting (5) into the hydraulic pump housing assembly (1).

    Tighten:  Tighten the O-ring union fitting to 75 N.m (55 lb ft).

scientia non olet · About Mike's Workshop Manuals