Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2000 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 232 (Engine Controls - 2.2L (L61) Introduction) >> Repair Instructions >> Intake Air Temperature (IAT) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Press the IAT sensor (4) into the air cleaner resonator (1).
    Fig 1: Locating IAT Sensor
    GM785335Courtesy of GENERAL MOTORS CORP.
  2. Connect the IAT sensor harness connector.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Connect the air cleaner duct to the air cleaner resonator.

    Tighten:  Tighten the clamp to 5 N.m (44 lb in).

scientia non olet · About Mike's Workshop Manuals