Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2000 >> Cavalier Base, 2D Coupe, Automatic, 3T40/MD9 >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules >> Removal & Installation >> Electronic Brake Control Module (EBCM) >> Removal & Installation

Removal & Installation

  1. Disconnect Electronic Brake Control Module (EBCM) harness connector. Disconnect EBCM harness from bracket. Remove EBCM mounting screws. Remove EBCM.
  2. Clean mounting surfaces. To install, reverse removal procedure. Tighten EBCM mounting bolts to 44 INCH lbs. (5 N.m). Perform ABS diagnostic system check. See appropriate ANTI-LOCK article in BRAKES.
scientia non olet · About Mike's Workshop Manuals