Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 1999 >> Venture Base, Van Cargo Extended >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Engine Control System - Removal, Installation & Overhaul) >> Fuel System >> Upper Intake Manifold Assembly >> Removal

Upper Intake Manifold Assembly: Removal

WARNING: This page is about a different car, the 1998 Pontiac Trans Sport, 1998 Oldsmobile Silhouette, and 1998 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable. Remove fuel injector sight shield. Drain cooling system. Disconnect necessary harness connectors. Remove air intake tube from throttle body. Disconnect control cables from throttle body.
  2. Disconnect left-bank spark plug wires from distributor and position aside. Disconnect coolant hose from throttle body. Remove EVAP canister solenoid valve. Remove ignition coil bracket with coils attached. Disconnect necessary vacuum hoses and remove vacuum harness.
  3. Remove side and rear generator brackets. Remove EGR valve. Remove MAP sensor and bracket. Remove upper intake manifold retaining bolts. Remove upper intake manifold and gasket.
scientia non olet · About Mike's Workshop Manuals