Disabling System
WARNING: This page is about a different car, the 1998 Pontiac Trans Sport, 1998 Oldsmobile Silhouette, and 1998 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
When SIR fuse is removed and ignition switch is in RUN position, AIR BAG warning light will be on. This does not indicate a system malfunction.
- Turn steering wheel to place vehicle wheels in straight-ahead position. Turn ignition switch OFF and remove key.
- Remove SIR fuse (15 amp) from instrument panel fuse block. Remove driver-side sound insulator panel. Remove Connector Position Assurance (CPA) clip and disconnect driver-side Yellow 2-pin connector at base of steering column. See Fig 1 .
- Remove passenger-side sound insulator panel. Remove CPA clip and disconnect passenger-side air bag Yellow 2-pin connector located behind sound insulator panel. See Fig 2 .
- Lift driver seat. Remove CPA clip and disconnect side air bag Yellow 2-pin connector. See Fig 3 . Remove CPA clip and disconnect seat belt pretensioner Yellow 2-pin connector. Lift passenger seat. Remove CPA clip and disconnect side air bag Yellow 2-pin connector. Remove CPA clip and disconnect seat belt pretensioner Yellow 2-pin connector.