Test Description

The numbers below refer to the step numbers on the diagnostic table. No information is missing.

2: This step tests for a short to ground in CKT 1836.

3: This step tests for the 5 volt reference in the Passlock module in order to determine if the module or the Passlock sensor need to be replaced.

TEST DESCRIPTION

Step	Action	Value(s)	Yes	No
1	Did you perform the VTD Diagnostic System Check?	--	Go to Step 2	Go to Diagnostic System Check - Theft Deterrent
2	Turn the ignition switch OFF. Disconnect the Passlock module connector. Refer to Theft Deterrent Module Replacement . Use a J 39200 digital multimeter (DMM) in order to measure the resistance from the Passlock/EVO module connector terminal B7 to ground. Is the resistance within the specified value?	(OL) infinite	Go to Step 3	Go to Step 6
3	Reconnect the Passlock module. Connect a fused jumper between the Passlock module connector terminal B8 and terminal B3. Use a scan tool in order to read the Passlock code. Does the Passlock code read open?	--	Go to Step 4	Go to Step 5
4	Remove the jumper. Replace the Passlock sensor in the electronic column lock module assembly. With Tilt Wheel To disassemble the lock module assembly, refer to ELECTRONIC COLUMN LOCK MODULE - DISASSEMBLE - OFF VEHICLE in Steering Wheel and Column - Tilt. To assemble the lock module assembly, refer to ELECTRONIC COLUMN LOCK MODULE - ASSEMBLE - OFF VEHICLE in Steering Wheel and Column - Tilt. With Standard Wheel To disassemble the lock module assembly, refer to ELECTRONIC COLUMN LOCK MODULE - DISASSEMBLE - OFF VEHICLE in Steering Wheel and Column - Standard. To assemble the lock module assembly, refer to ELECTRONIC COLUMN LOCK MODULE - ASSEMBLE - OFF VEHICLE in Steering Wheel and Column - Standard. Is the repair complete?	--	Go to Step 7	--
5	Remove the jumper. Replace the Passlock module. Refer to Theft Deterrent Module Replacement . Is the repair complete?	--	Go to Step 7	--
6	Repair the short to ground in CKT 1836. Is the repair complete?	--	Go to Diagnostic System Check - Theft Deterrent	--
7	Reconnect all of the previously disconnected connectors and the components. Turn the ignition switch ON Connect the scan tool. Clear the DTCs. Perform one of the following Passlock reprogramming procedures: PASSLOCK Reprogramming Seed and Key PASSLOCK Reprogramming Auto Learn	--	Go to Diagnostic System Check - Theft Deterrent	--