Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 1998 >> Venture Base, Van Cargo Extended >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Control System - Removal, Installation & Overhaul >> Fuel System >> Throttle Position (TP) Sensor >> Removal & Installation

Removal & Installation

  1. Remove air cleaner assembly (if necessary). Disconnect harness connector from TP sensor. Remove attaching screws, lock washers, retainers, and TP sensor.
  2. To install, reverse removal procedure. Adjust TP sensor to specification. See ADJUSTMENTS article. When replacing a TP sensor, ensure correct part number is used. Use Loctite on TP sensor attaching screws.
scientia non olet · About Mike's Workshop Manuals