Wiper System And Washer System: Operation: Notes

Turn ignition switch to RUN position. Turn washer switch to OFF position, press washer switch to ON position. Wiper should operate at low speed. Washer should spray as long as switch is held in ON position. After switch is released, washer should stop and wipers should return to park position after 2-4 sweeps. In DELAY mode, wipers should make one complete sweep, then pause 1-22 seconds before next sweep, depending on delay setting.

In LO speed, wipers should run continuously at low speed. In HI speed, wipers should run continuously at a higher rate of speed. When switch is pushed down to MIST position, wipers should cycle once and return to park position.