Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 1998 >> Cavalier LS, 2.4 T >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Removal & Installation - 2.4L >> Ignition System >> Ignition Control Module (IDI) >> Removal

Ignition Control Module (IDI): Removal

  1. Disconnect negative battery cable. Disconnect 11-pin harness connector. Remove 4 IDI cover assembly-to-camshaft housing bolts. Remove ignition system assembly from engine.
  2. Remove 4 coil housing-to-cover screws. Remove housing cover. Remove coil harness connector from module. Remove module-to-cover screws. Remove module from cover.
NOTE: DO NOT wipe grease from module or coil if module is not being replaced. If installing a NEW module, spread silicone grease on metal face of module and on cover where module seats. Grease is included with NEW module and is necessary for module cooling purposes.
scientia non olet · About Mike's Workshop Manuals