Rear Glass Release Available With Ignition Switch In RUN

Position & Transmission Out Of Park

1) Disconnect RCDLR connector C2. Turn ignition switch to RUN position. Connect test light between RCDLR connector C2 terminal "B" (Pink wire) and ground. If test light lights, go to next step. If test light does not light, repair open or short to ground in Pink wire.

2) Set parking brake. Shift transmission to Drive. Connect test light between connector C2 terminal "C" (Light Green wire) and ground. If test light lights, check for short to voltage in Light Green wire. If Light Green wire is okay, replace transmission position switch. If test light does not light, check for poor connection at keyless receiver connector C2 terminal "B" (Pink wire). If connection is okay, replace RCDLR.