Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 1991 >> Astro Van Cargo Extended, AWD, 4L60/MD8 >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Wheel Alignment Specifications & Procedures) >> Pre-Alignment Checks >> Vehicle Checks

Vehicle Checks

WARNING: This page does not describe the selected car, but rather 35 other vehicles, including the 1992 Pontiac Trans Sport, 1992 Oldsmobile Silhouette, 1992 Oldsmobile Bravada, 1992 GMC Yukon, and 1992 GMC Vandura Special. However, it is still accessible from the selected car via links, so may be relevant.

Before making wheel alignment adjustments:

  1. Tire pressure must be inflated to manufacturer's recommended specification. Tires should be equal in size and type. Runout must not be excessive. Tires and wheels should be in balance.
  2. Wheel bearings must be properly adjusted. Steering linkage and suspension must not have excessive wear and/or looseness. Check for wear in tie rod ends and ball joints.
  3. Steering gear box must not have excessive play. Check and adjust to manufacturer's specification.
  4. Vehicle must be at correct ride height with full fuel load and spare tire in vehicle. No extra load should be on vehicle. See RIDE HEIGHT  under ALIGNMENT PROCEDURES.
  5. Vehicle must be level with floor and with suspension settled. Jounce front and rear of vehicle several times and allow it to settle to normal ride height.
  6. Ensure steering wheel spokes are centered with front wheels in straight-ahead position. Correct by shortening one tie rod adjusting sleeve and lengthening opposite sleeve in equal amounts.
  7. Ensure wheel lug nuts are tightened to proper specification. See TORQUE SPECIFICATIONS .
scientia non olet · About Mike's Workshop Manuals