Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 1987 >> Corvette 2D Convertible, Automatic >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock >> Diagnosis & Testing >> Test F - Wheel Speed Sensor >> Test Procedures

Test Procedures

  1. Measure resistance between pins No. 4 (Yellow wire) and No. 6 (Lt. Blue). Resistance should be 900-1500 ohms. If not, check left front wheel sensor for proper connection. Check connector, under left side of cargo compartment, behind seat, for damage. Check sensor wires for opens. If wiring is good and sensor resistance is incorrect, replace sensor.
  2. Measure resistance between pins No. 11 (Dark Green) and No. 21 (Tan). Resistance should be between 900-1500 ohms. If not, check right front wheel sensor for proper connection. Check connector, under left side of cargo compartment, for damage. Check sensor wires for opens. If wiring is good and sensor resistance is incorrect, replace sensor.
  3. Measure resistance between pins No. 9 (Black) and No. 8 (Red). Resistance should be 900-1500 ohms. If not, check left rear wheel sensor connector for proper connection. Check connector, under left side of cargo compartment, for damage. Check sensor wires for opens. If wiring is good and sensor resistance is incorrect, replace sensor.
  4. Measure resistance between pins No. 24 (Brown) and No. 26 (White). Resistance should be 900-1500 ohms. If not, check right rear wheel sensor connector for proper connection. Check connector, under left side of cargo compartment, for damage. Check sensor wires for opens. If wiring is good and sensor resistance is incorrect, replace sensor.
scientia non olet · About Mike's Workshop Manuals