Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 1976 >> Chevette Base, Standard Trans >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> Component Replacement >> General Motors CADILLAC >> Receiver-Drier >> All Models >> Replacement

All Models: Replacement

  1. Discharge system and remove all dirt and grease from exterior of assembly housing. With system fully discharged, loosen receiver-drier shell retaining screws three turns. Disconnect mounting bracket from receiver shell. Hold EEVIR housing and push on lower end of receiver shell to break seal.
  2. Remove retaining bolts and shell by lowering downward to clear pickup tube and filter. Remove and discard desiccant bag and "O" ring. Drain, measure and discard any oil in receiver shell. Clean filter screen and interior of shell. To install, reverse removal procedure. Add to receiver shell one ounce of refrigerant oil, plus amount drained and amount lost during discharge of system. Lubricate new "O" ring with refrigerant oil. Evacuate, leak test, and charge system.
scientia non olet · About Mike's Workshop Manuals