Removal Procedure
Using a flat-bladed plastic trim tool, release the retaining clips.
- Windshield Multifunction Sensor Mount Bracket Cover Insert (1) - Remove
Using a suitable plastic trim tool, carefully pry downward on the windshield multifunction sensor mount bracket cover (1) to release it from the windshield.
- Windshield Multifunction Sensor Mount Bracket Cover (1) - Remove
Disconnect all electrical connectors, if equipped.
- Inside Rearview Mirror Bolt (1) - Remove
- Inside Rearview Mirror (2) - Remove
Disconnect the headlamp automatic control ambient light sensor wiring harness connector (1) from the headliner wiring harness connector.
- Unclip the windshield outside moisture/ambient light and humidity sensor (3) from the inside rear view mirror bracket and lower.
- Disconnect the headlamp automatic control ambient light sensor wiring harness connector (2) from the windshield outside moisture/ambient light and humidity sensor (3).
- Windshield Outside Moisture/Ambient Light and Humidity Sensor (3) - Remove and DISCARD
Disconnect the electrical connector.
- Release the retaining tabs.
- Slide the front view camera (1) upward to release.
- Front View Camera (1) - Remove
- NOTE:
Do NOT remove or service the sensor farm pins.
Front View Driver Information Camera Bracket (1) - Remove
- Release the front view driver information camera bracket (1) retaining tabs and slide the bracket upward to disengage the sensor farm pins.
- Gently pull the front view driver information camera bracket (1) away from the windshield.
NOTE:
Slide the inside rearview mirror off the mirror mount.
NOTE:
Observe the mounting and location of the front view camera to ensure proper reinstallation.