Installation Procedure
Clean the inside of the windshield before installing the front view driver information camera bracket (1).
- Front View Driver Information Camera Bracket (1) - Install
Front View Camera (1) - Install
- Slide the front view camera (1) downward to engage.
- Secure the retaining tab.
- Connect the electrical connector.
Prior to the installation of the of the windshield outside moisture/ambient light and humidity sensor (3), clean the windshield surface and sensor bracket with an isopropyl alcohol wipe until the surfaces are thoroughly clean.
- Connect the headlamp automatic control ambient light sensor wiring harness connector (2) to the windshield outside moisture/ambient light and humidity sensor (3).
- Windshield Outside Moisture/Ambient Light and Humidity Sensor (3) - Install NEW
- Connect the headlamp automatic control ambient light sensor wiring harness connector (1) to the headliner wiring harness connector.
- NOTE:
Slide the inside rearview mirror onto the mirror mount.
Inside Rearview Mirror (2) - Install
- Inside Rearview Mirror Bolt (1) - Install - Fastener Specifications
- Connect all electrical connectors, if equipped.
Windshield Multifunction Sensor Mount Bracket Cover (1) - Install
Windshield Multifunction Sensor Mount Bracket Cover Insert (1) - Install
- Apply pressure upward on the windshield multifunction sensor mount bracket cover insert (1) to engage the retaining tabs.
- Perform the camera calibration procedure. Front View Camera - Windshield Learn
CAUTION:
Refer to Fastener Caution .