Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2019 >> XTS Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 83 (Supplemental Restraint System) >> Repair Instructions >> Airbag Front Passenger Presence Module Replacement

Airbag Front Passenger Presence Module Replacement

WARNING: This page is about a different car, the 2018 Cadillac XTS. However, it is still accessible from the selected car via links, so may be relevant.
GM2769489
Callout Component Name
WARNING:

Refer to SIR Warning .

WARNING:

Replace the passenger presence system as a complete assembly to prevent possible injury to the occupant. All the components in the service kit are assembled and calibrated as a unit. Using only some of the components in the service kit will cause the passenger presence system to operate improperly.

WARNING:

To avoid personal injuries, re-zero the passenger presence system whenever you remove or replace the seat cushion or trim. Failure to do so may cause the system to malfunction.

Preliminary Procedure

  1. Disable the SIR system. Refer to. SIR Disabling and Enabling 
  2. Remove the driver or passenger seat. Refer to. Driver or Passenger Seat Removal and Installation
  3. Remove the front seat cushion cover and pad. Refer to Front Seat Cushion Cover and Pad Replacement .
1 Front Seat Cushion Cover
2 Inflatable Restraint Front Passenger Presence Module

Procedure

  1. Disconnect the electrical connectors.
  2. The passenger presence system is an integral part of the pad on the passenger seat cushion.
  3. Note the routing of the wiring harness and connector location for installation.
  4. Re-zero the inflatable restraint passenger presence system after replacement. Refer to Passenger Presence System Rezeroing 
scientia non olet · About Mike's Workshop Manuals