Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2019 >> CTS Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Negative Cable Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2018 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM3461598Courtesy of GENERAL MOTORS COMPANY

    Install the battery current sensor (1) into position on the battery negative cable (2).

  2. GM3461597Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

    Install the battery negative cable (1) to the ground stud and tighten the fastener (2) to 22 N.m (16 lb ft).

  3. Install the body harness ground terminal (4) to the battery negative cable and tighten the fastener (3) to 7 N.m (62 lb in).
  4. Connect the body harness connector (6) to the battery current sensor (5).
  5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (without KL9) Battery Negative Cable Disconnection and Connection (with KL9) .
  6. Install the left rear compartment side trim panel. Refer to Rear Compartment Side Trim Replacement - Left Side .
scientia non olet · About Mike's Workshop Manuals