Electronic Suspension Front Position Sensor Replacement: Installation
WARNING: This page is about a different car, the 2018 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
- NOTE:
Ensure that the level senor is properly seated on the frame rail.
Position the level sensor stud (2) into the slot in frame rail (3) slide it toward the engine.
- Tighten the level senor nut (1) to 9 N.m (80 lb in).
Install the level sensor link (1) on the lower control arm ball stud (2).
Reconnect the level sensor electrical connector (1) to the electronic level sensor.
- Install the right front wheel house liner. Refer to Front Wheelhouse Liner Replacement (CTS)Front Wheelhouse Liner Replacement (CTS-V) .
- Remove the support and lower the vehicle.
- Reprogram the level sensor.
CAUTION:
Refer to Fastener Caution .