Circuit/System Verification

P1E20 or P1E21

1. Vehicle ON.
2. Verify DTC P1E20 or P1E21 is not set.
   • If any of the DTCs are set 
   1. Verify the T6 Power Inverter Module has the latest calibration in Calibration Information.
      • If the T6 Power Inverter Module does not have the latest calibration, program the T6 power inverter module.
      • If the T6 Power Inverter Module has the latest calibration, replace the T6 Power Inverter Module.
   2. Verify the DTC does not set.
      • If the DTC sets, replace the T6 Power Inverter Module.
      • Go to next step: If the DTC does not set.
   3. All OK
   • Go to next step: If none of the DTCs are set 
3. All OK

P1E22

1. Vehicle ON.
2. Verify DTC P1E22 is not set.
   • If the DTC is set 

     Refer to Loss of Isolation on the High Voltage Main Bus .

   • Go to next step: If the DTC is not set 
3. All OK