Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

If you are replacing the battery with a serviced NEW battery, detach the vent plug (1), that comes with the positive post cover.
Courtesy of GENERAL MOTORS COMPANY

Install the vent plug (1), opposite side of the battery vent hose (2).
Courtesy of GENERAL MOTORS COMPANY

Battery (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Battery Vent Tube (2) - Engage
Battery Hold Down Retainer (3) - Install

CAUTION:

Battery Hold Down Bolt (1) - Install and tighten 22 N.m (16 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Spare Wheel Carrier Bracket (2) - Install
Spare Wheel Stowage Bracket Bolt (1) - Install and tighten [2X] 22 N.m (16 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Battery Positive Cable (3) - Install
Battery Positive Post Clamp Nut (1) - Tighten 4.5 N.m (40 lb in)
Battery Positive Post Cover (2) - Install
Connect the negative battery cable. Battery Negative Cable Disconnection and Connection
Courtesy of GENERAL MOTORS COMPANY

Spare Tire (2) - Install
Spare Tire Stowage Retainer (1) - Hand tighten
Rear Compartment Floor Panel Trim - Install - Rear Compartment Floor Panel Trim Replacement (Without HP9)Rear Compartment Floor Panel Trim Replacement (With HP9)