Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2017 >> CTS Base, AWD >> Repair and Diagnosis >> Suspension >> Front Suspension >> Front Suspension System >> Repair Instructions >> Front Lower Control Front Link Replacement (Non V-Series With AWD) >> Installation Procedure

Installation Procedure

    Fig 1: Front Lower Control Front Link Nut
    GM3460356Courtesy of GENERAL MOTORS COMPANY
  1. Position the front lower control front link (2) in the steering knuckle ball joint (4).
  2. Position the front lower control front link (2) in the frame.
    3. CAUTION:

    This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.

  3. Install the NEW front lower control front link bolt (3) and OLD nut (1).
    4. CAUTION:

    Refer to Fastener Caution .

  4. Tighten the NEW front lower control front link bolt (3).

    Tighten

    1. First Pass: 100 N.m (74 lb ft)
    2. Final Pass: (90-105 degrees)
    5. Fig 2: Steering Knuckle Nut
    GM3460352Courtesy of GENERAL MOTORS COMPANY
  5. Install and tighten the OLD steering knuckle nut (1).

    Tighten

    1. First Pass: 40 N.m (30 lb ft)
    2. Final Pass: (120-135 degrees)
  6. Connect any harnesses or retainers previously disconnected from the front lower control front link.
  7. Install Front Wheelhouse Liner Replacement
  8. Install Front Compartment Lower Noise Shield Replacement (AWD)
  9. Install the front tire and wheel assembly. Tire and Wheel Removal and Installation
  10. Measure and adjust the wheel alignment. Wheel Alignment Measurement
scientia non olet · About Mike's Workshop Manuals