Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2017 >> CT6 Plug-In >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Battery, Charging System And Starting System - Except Hybrid) >> Diagnostic Information and Procedures >> Stop/Start System Malfunction >> Circuit/System Testing >> Auto Stop Mode Switch Circuit Malfunction

Auto Stop Mode Switch Circuit Malfunction

WARNING: This page is about a different variant/trim than selected.
  1. Ignition OFF, disconnect the harness connector at the S48C Multifunction Switch - Instrument Panel, ignition ON.
  2. Verify the scan tool Stop/Start Select Switch parameter is Inactive.
    • If not Inactive 
    1. Ignition OFF, disconnect the X3 harness connector at the K9 Body Control Module.
    2. Test for infinite resistance between the signal circuit terminal 14 and ground.
      • If less than infinite resistance, repair the short to ground on the circuit.
      • If infinite resistance, replace the K9 Body Control Module.
    • If Inactive 
  3. Install a 3 A fused jumper wire between the signal circuit terminal 11 and ground.
  4. Verify the scan tool Stop/Start Select Switch parameter is Active.
    • If not Active 
    1. Ignition OFF, disconnect the X3 harness connector at the K9 Body Control Module, ignition ON.
    2. Test for less than 1 V between the signal circuit and ground.
      • If 1 V or greater, repair the short to voltage on the circuit.
      • If less than 1 V
    3. Ignition OFF.
    4. Test for less than 2 Ω in the signal circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance on the circuit.
      • If less than 2 Ω, replace the K9 Body Control Module.
    • If Active 
  5. Test or replace the S48C Multifunction Switch - Instrument Panel.
scientia non olet · About Mike's Workshop Manuals