Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2017 >> CT6 Plug-In >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Battery, Charging System And Starting System - Except Hybrid) >> Diagnostic Information and Procedures >> DTC P15A3: Stop/Start Select Switch Circuit Signal Message Counter Incorrect >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition ON
  2. Verify no DTCs are set in the K9 Body Control Module.
    • If no DTCs are set 
  3. Verify the scan tool Stop/Start Select Switch parameter changes between Active and Inactive when pressing and releasing the ECO switch.
    • If the parameter does not change 

      Refer to Circuit/System Testing

    • If the parameter changes 
  4. All OK.
scientia non olet · About Mike's Workshop Manuals