Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2017 >> ATS V, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 3.6L (LGX LF4) - Repair Instructions >> Repair Instructions >> Fuel Tank Replacement >> Installation Procedure

Installation Procedure

  1. Install the following components if fuel tank replacement was necessary:
    1. Fuel tank fuel pump module. Refer to Fuel Tank Fuel Pump Module Replacement .
    2. Fig 1: Fuel Tank
    GM2815733Courtesy of GENERAL MOTORS COMPANY
  2. Use a suitable jack and install the fuel tank (1).
    3. Fig 2: Fuel Tank Straps And Bolts
    GM2815736Courtesy of GENERAL MOTORS COMPANY
  3. Install the fuel tank straps (2).
    4. CAUTION:

    Refer to Fastener Caution .

  4. Install the fuel tank strap bolts (1) and tighten to 20 N.m (15 lb ft).
  5. Connect the fuel tank electrical connector.
    6. Fig 3: Evaporative Emission And Fuel Pipes
    GM2815749Courtesy of GENERAL MOTORS COMPANY
  6. Install the filler pipe and tighten the hose clamps (1).
  7. Connect the evaporative emission and fuel pipes (2). Refer to Plastic Collar Quick Connect Fitting Service .
  8. Install the two piece propeller shaft. Refer to Two-Piece Propeller Shaft Replacement (LTG, LGX, LCV)Two-Piece Propeller Shaft Replacement (LF4) .
  9. Install the left and right side rear air deflectors. Refer to Underbody Rear Air Deflector Replacement - Left Side , and Underbody Rear Air Deflector Replacement - Right Side .
  10. Refill the fuel tank.
  11. Inspect for fuel leaks.
scientia non olet · About Mike's Workshop Manuals