Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2016 >> SRX Base >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Power Door Lock System And Release Systems >> Repair Instructions >> Front Side Door Outside Handle Replacement (Base) >> Installation Procedure

Installation Procedure

    Fig 1: Door Handle
    GM2595975Courtesy of GENERAL MOTORS COMPANY
  1. Install the door handle (1) to the door (2) as follows:
    1. Insert the door handle into the door handle pocket.
    2. Slide the door handle forward securing it into the door handle bracket.
    2. Fig 2: Side Door Outside Handle
    GM2212931Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Handle will snap back to flush condition, continue to turn the fastener in the clockwise (right) direction until proper torque is reached.

  2. Install the bezel with cylinder / cover and blank cylinder (1) in the door.

    Hold the bezel or cover flush to the door sheet metal and turn the cylinder clamp screw (2) until proper torque is reached.

  3. Tighten the screw to 6 N.m (53 lb in).
    4. Fig 3: Cover Cap
    GM2019726Courtesy of GENERAL MOTORS COMPANY
  4. Install the cover cap that conceals the screw (1) to the inside edge of the door.
  5. Ensure that the door lock system operates properly.
scientia non olet · About Mike's Workshop Manuals