Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2016 >> CTS Base, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 2.0L (LTG) - DTC P0010 To DTC P0341 >> Diagnostic Information and Procedures >> DTC P00F4-P00F6: Intake Air Humidity Sensor Circuit >> Circuit/System Verification

Circuit/System Verification

NOTE: To minimize the effects of residual engine heat and sensor internal heating elements, perform Steps 1 and 2 of this verification procedure only if the ignition has been OFF for 8 hours or more.
  1. Ignition ON.
  2. Verify the following scan tool parameters are within 25°C (45°F) of each other.
    • Start-Up IAT Sensor 1
    • Start-Up IAT Sensor 2
    • Start-Up IAT Sensor 3; where equipped
    • If not within 25°C (45°F) 

      Refer to Circuit/System Testing.

    • If within 25°C (45°F) 
  3. Engine idling, verify the scan tool Intake Air Humidity parameter is between 5 and 90%.
    • If not between 5 and 90% 

      Refer to Circuit/System Testing.

    • If between 5 and 90% 
  4. Operate the vehicle within the conditions for running the DTC. You may also operate the vehicle within the conditions that you observed from the freeze frame/failure records data.
  5. Verify the DTC does not set.
    • If the DTC sets 

      Refer to Circuit/System Testing.

    • If the DTC does not set 
  6. All OK
scientia non olet · About Mike's Workshop Manuals