Installation Procedure

Fig 1: Front Side Door Outside Bracket Counter Balance & Wire Harness Retainers

Courtesy of GENERAL MOTORS COMPANY

NOTE:

It may be necessary to transfer the wire harness retainers (2) to the new bracket.

Set the rear side door outside handle bracket counter balance (1) as follows:
1. The outside door handle can Not be install until the counter balance (1) is reset.
2. Grasp the rear side door outside handle bracket (2) with one hand.
3. From the back side of the counter balance (1), push forward until the counter balance locks into the detent of the handle bracket.
Install the rear side door outside handle cable. Refer to Rear Side Door Outside Handle Cable Replacement .

Fig 2: Door Outside Handle Bracket & Latch

Courtesy of GENERAL MOTORS COMPANY

NOTE:

Ensure that the counter balance is reset and locked in the detent of the handle bracket. The counter balance can't Not be reset after the latch and handle bracket has been reinstalled in the door.
Bracket should be slid full rearward prior to tightening bracket screw.

Install the outside handle bracket (1) and the rear side door latch (2) assembly to the vehicle. Refer to Rear Side Door Latch Replacement .

Fig 3: Front Side Door Outside Bracket & Screws

Courtesy of GENERAL MOTORS COMPANY

CAUTION:

Install the rear side door outside bracket screw to the door (2) and tighten to 5 N.m (44 lb in).
Install the rear side door outside handle. Refer to Rear Side Door Outside Handle Replacement .
Ensure that the door lock system operates properly before installing the trim.