Liftgate Close Actuator Motor Control Module Replacement (Except Escalade EXT)

Fig 1: Liftgate Close Actuator Motor Control Module (Except Escalade EXT)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove the bodyside trim panel. Refer to Rear Quarter Trim Panel Replacement - Left Side (Standard Wheelbase w/E61) , Rear Quarter Trim Panel Replacement - Left Side (Extended Wheelbase w/E61) , Rear Quarter Trim Panel Replacement - Left Side (Extended Wheelbase w/o E61) , Rear Quarter Trim Panel Replacement - Left Side (Standard Wheelbase w/o E61) . Disconnect the power liftgate actuator rod. Refer to Liftgate Actuator Rod Replacement (Except EXT Escalade) .
1	Liftgate Close Actuator Motor Control Module Procedure Disconnect the electrical connector. Cut the tie strap, if equipped.
2	Liftgate Close Actuator Motor Control Module Bolt (Qty: 3) CAUTION: Refer to Fastener Caution . Tighten 9 N.m (80 lb in)
3	Liftgate Close Actuator Motor Control Module Procedure If a replacement control module is installed, program the module. Refer to Control Module References .