Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2013 >> SRX Base >> Repair and Diagnosis >> Accessories & Equipment >> Memory Modules >> Adjustable Pedal System >> Repair Instructions >> Brake Pedal Assembly Replacement >> Removal Procedure

Removal Procedure

NOTE:

Move the adjustable pedal assembly to the full forward, front of vehicle position prior to removing components. Failure to place the adjustable pedal assembly in the full forward position may result in incorrect accelerator and brake pedal step-over height and improper adjustable pedal function.

  1. Move the adjustable pedal assembly to the full forward, front of vehicle position.
  2. Turn the ignition to the OFF position.
  3. Remove the instrument panel tie bar. Refer to Instrument Panel Tie Bar Replacement .
  4. Remove the brake pedal position sensor. Refer to Brake Pedal Position Sensor Replacement .
    5. Fig 1: Power Vacuum Brake Booster Pushrod Retainer
    GM2221062Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Do not reuse the power vacuum brake booster pushrod retainer.

  5. Release the power vacuum brake booster pushrod retainer (1) from the brake pedal by pulling the brake pedal rearward.
  6. Discard the power vacuum brake booster pushrod retainer.
  7. Disconnect the accelerator pedal position sensor electrical connector.
  8. Disconnect the adjustable pedal assembly electrical connector.
  9. Remove the power vacuum brake booster. Refer to Power Vacuum Brake Booster Replacement .
    10. Fig 2: Identifying Brake Pedal Assembly Nuts
    GM2221066Courtesy of GENERAL MOTORS COMPANY
  10. Remove the brake pedal assembly nuts (1).
  11. Remove the adjustable pedal assembly.
scientia non olet · About Mike's Workshop Manuals