Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2013 >> ATS 2.0L Eng VIN X, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls/Fuel - 3.6L (LFX) - Repair Instructions) >> Repair Instructions >> Fuel Pump Flow Control Module Replacement

Fuel Pump Flow Control Module Replacement

WARNING: This page is about a different variant/trim than selected.
Fig 1: Chassis Control Module
GM2834499Courtesy of GENERAL MOTORS COMPANY
Fuel Pump Flow Control Module Replacement

Callout Component Name
Preliminary Procedure 
Remove the rear compartment left side fuse access panel.
1 Fuel Pump Flow Control Module Fastener
CAUTION:

Refer to Fastener Caution .


Tighten 
7 (62 lb in)
2 Fuel Pump Flow Control Module

Procedure

  1. Disconnect the electrical connector.
  2. If replacing, reprogram the module. Refer to Control Module References .
scientia non olet · About Mike's Workshop Manuals