Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of EBCM

Courtesy of GENERAL MOTORS CORP.

Position the EBCM (1) to the BPMV.
Push the EBCM squarely onto the BPMV.

Fig 2: View Of EBCM Bolts

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

Install the EBCM bolts (1) and tighten in a cross pattern to 3 N.m (27 lb in).
Connect the EBCM electrical connector.
If installing a new EBCM, the EBCM must be programmed and the sensor and boost valve calibration and EBCM learn processes must be performed. Refer to Control Module References .

Fig 3: Identifying ABS Module Splash Shield

Courtesy of GENERAL MOTORS CORP.

Install the ABS module splash shield (1).

Fig 4: Identifying ABS Module Splash Shield Bolts

Courtesy of GENERAL MOTORS CORP.

Install the ABS module splash shield bolts (1) and tighten to 20 N.m (15 lb ft).

Fig 5: Identifying Antilock Brake System (ABS) Module Splash Shield Retainer

Courtesy of GENERAL MOTORS CORP.

Install the ABS module splash shield retainer (1).