Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2012 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1563 (Engine Control System & Fuel System - 4.3L - Repair Instructions) >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Wiring Harness Electrical Connector
    GM1876318Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the engine wiring harness electrical connector (1) from the manifold absolute pressure (MAP) sensor.
    2. Fig 2: View Of MAP Sensor & Bolt
    GM1876319Courtesy of GENERAL MOTORS CORP.
    CAUTION: Do not rotate or pry on the MAP sensor when removing. Damage to the MAP sensor or the intake manifold may result.
  2. Remove the MAP sensor bolt (1).
  3. Using a slight rocking motion while pulling straight up, remove the MAP sensor (2) from the upper intake manifold.
  4. Inspect the MAP sensor seal for damage, replace the seal if necessary.
scientia non olet · About Mike's Workshop Manuals