Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2012 >> Escalade EXT >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls/Fuel - 5.3L, 6.0L, 6.2L - DTC P0010 To DTC P0358 >> Diagnostic Information and Procedures >> DTC P0230 (FPCM) >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the K27 FPCM.
  2. Connect a test lamp between the control circuit terminal 13 and ground.
  3. Ignition ON, command the fuel pump ON and OFF with a scan tool. The test lamp should turn ON and OFF with each command.
    • If the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the K20 engine control module.
    • If the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K20 engine control module.
  4. If all circuits test normal, replace the K27 FPCM.
scientia non olet · About Mike's Workshop Manuals