Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2012 >> Escalade EXT >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Wiring Systems And Power Management - Repair Instructions >> Repair Instructions >> Ignition and Start Switch Replacement >> Removal Procedure

Removal Procedure

    WARNING:

    Refer to SIR Warning .

  1. Remove the theft deterrent module. Refer to Theft Deterrent Module Replacement .
  2. Disconnect the passlock and key buzzer from the ignition lock cylinder case.
    3. Fig 1: Inserting J 42759 Into The Lock Cylinder Housing To Release The Tabs On The Ignition Switch
    GM1413831Courtesy of GENERAL MOTORS COMPANY
  3. Insert release tool J-42759  ignition switch connector release tool into the ignition lock cylinder case to release the tabs on the ignition/start switch.
  4. Pull the ignition and start switch out of the ignition lock cylinder case.
  5. Disconnect the electrical connector from the ignition/start switch.
scientia non olet · About Mike's Workshop Manuals