Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2012 >> CTS Base, 2D Coupe, AWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System >> Repair Instructions >> Electronic Brake and Traction Control Module with Brake Pressure Modulator Valve Replacement (CTS-V) >> Installation Procedure

Installation Procedure

    Fig 1: View Of EBCM & Brake Pressure Modulator Valve
    GM2090845Courtesy of GENERAL MOTORS COMPANY
  1. Clean the sealing surfaces of the BPMV and the EBCM.
  2. Install the EBCM (1) to the BPMV.
    3. Fig 2: Identifying EBCM Screws
    GM2090843Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  3. Install the EBCM screws (1) and tighten in a cross pattern to 5 N.m (44 lb in).
  4. Connect the EBCM electrical connector.
  5. Position the washer solvent container and install the fasteners. Refer to Windshield Washer Solvent Container Replacement (Without CE4) , Windshield Washer Solvent Container Replacement (With CE4) .
  6. Install the right front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
  7. Lower the vehicle.
  8. If installing a new EBCM, program the EBCM. Refer to Control Module References .
  9. Perform the Diagnostic System Check - Vehicle .
scientia non olet · About Mike's Workshop Manuals