Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2011 >> STS AWD >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Battery Negative Cable Replacement (LLT With Side Post) >> Removal Procedure

Removal Procedure

NOTE:
  • Always use replacement cables that are of the same type, diameter and length of the cables that you are replacing.
  • Always route the replacement cable the same as the original cable.
    Fig 1: Instrument Panel (I/P) Harness Electrical Connector
    GM1484712Courtesy of GENERAL MOTORS COMPANY
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (With Side Post) , Battery Negative Cable Disconnection and Connection (With Top Post) .
  2. Disconnect the instrument panel (I/P) harness electrical connector (1) from the battery current sensor.
    3. Fig 2: View Of Battery Area Mounts And Connectors
    GM772418Courtesy of GENERAL MOTORS COMPANY
  3. Remove the bolt (1) securing the negative battery cable to the side rail.
  4. Disconnect the body harness connector (3) from the negative battery cable.
    5. Fig 3: Identifying Stud Securing Battery Negative Cable To Engine Block
    GM1522523Courtesy of GENERAL MOTORS COMPANY
  5. Remove the stud securing the negative battery cable to the engine block.
  6. Lower the vehicle.
  7. Remove the negative battery cable.
scientia non olet · About Mike's Workshop Manuals