Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2011 >> Escalade EXT >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 5.3L, 6.0L & 6.2L - DTC P0010 Through DTC P0442 >> Diagnostic Information and Procedures >> DTC P0010 >> Component Testing >> Dynamic Test

Dynamic Test

  1. Remove the Camshaft Position Actuator Magnet.
    2. NOTE:
    • The Camshaft Position Actuator Magnet pintle should be facing downward for this test.
    • Do not allow electrical current to flow through the Camshaft Position Actuator Magnet for greater than 1-2 s.
  2. Install a 20 A fused jumper wire between the control circuit terminal 2 and B+. Momentarily install a jumper wire between the low reference terminal 1 and ground. The pintle should extent.
    • If the function does not perform as specified, replace the Camshaft Position Actuator Magnet.
scientia non olet · About Mike's Workshop Manuals